Search found 3 matches

Return

by medelec35
Tue Dec 14, 2010 9:18 pm
Jump to forum
Jump to topic

Re: HP299-Flowkit problem with EB006-00-6

e) The Flowkit switch in ICD position (yellow led goes off, EB-006 -00-6 board) The 3 red leds from HP299 are on. Not sure if you already know, but when Running in ICD mode and Flowkit is communicating, the red leds fade in and out so are not solid. You could try Downloading latest drivers from her...
by Benj
Fri Dec 10, 2010 3:05 pm
Jump to forum
Jump to topic

Re: HP299-Flowkit problem with EB006-00-6

Hello Taurus,

I would wire up as in Fig A and then assuming the ICD / PROG switch is in the ICD position then the debugging should work ok.

Have you seen this guide to getting up and running with ICD.
http://www.matrixmultimedia.com/softwar ... _Guide.pdf
by medelec35
Fri Dec 31, 2010 2:34 pm
Jump to forum
Jump to topic

Re: Flowcode V3 start instead V4

This will help: http://support.microsoft.com/kb/307859 I just hold shift key down, right click on file I want to open, Choose 'open with' in the context menu that appears with right clicking. Select Choose default program, then browse to program files/matrixmultia/Flowcode V4, then select Flowcode_P...