Search found 7 matches

Return

by medelec35
Sun Dec 23, 2018 5:49 pm
Jump to forum
Jump to topic

Re: PIC16F15355 Uart and ADC problem

You're welcome,
Have you tried here?
by medelec35
Mon Dec 24, 2018 12:25 pm
Jump to forum
Jump to topic

Re: PIC16F15355 Uart and ADC problem

Hi Patrick, Attached are the two updated files: 16F15355.fcdx goes in C:\Program Files (x86)\Flowcode 7\FCD (if 64bit windows) or C:\Program Files\Flowcode 7\FCD (if 32bit windows) PIC_CAL_ADC.c goes in C:\Program Files (x86)\Flowcode 7\CAL\PIC (if 64bit windows) or C:\Program Files\Flowcode 7\CAL\P...
by medelec35
Wed Dec 26, 2018 8:01 pm
Jump to forum
Jump to topic

Re: PIC16F15355 Uart and ADC problem

Hi Patrick,
Can you see if the attached solves your issues?
by medelec35
Thu Dec 27, 2018 9:17 pm
Jump to forum
Jump to topic

Re: PIC16F15355 Uart and ADC problem

medelec35 wrote:Try adding a c code block at the start with

Code: Select all

T2CLKCON = 1;

You will need the above code for timer 2 to work, including PWM
by medelec35
Sat Dec 28, 2019 12:24 pm
Jump to forum
Jump to topic

Re: XC Compiler Pro mode

Hi Patrick,
Did you set up V2.10 the same as in this post?
From V2.0 Microchip has changed the way the compilers work.
therefore you can't use the same Flowcode compiler batch file for xc8 2.00 and above.
It just won't work as well.
by Benj
Mon Jan 13, 2020 12:25 pm
Jump to forum
Jump to topic

Re: No internal EEProm with use of bootloader

Hello, Hmm this is strange, looking at the code for the 16F18857 device we do use the NVM type code to access the EEPROM. This could potentially be being effected by the code shift which to me would possibly be a compiler bug. Specifically these lines. NVMADRL = Address & 0xff; NVMADRH |= 0xF0; ...
by andreeksteen
Mon Jan 06, 2020 1:18 pm
Jump to forum
Jump to topic

Re: Bad mistake in FC8!

Hallo Christina, Thank you so much for the great advice! I actually took it a step further: 1: Uninstall Flowcode 8 and all associated items (Pic8, Pic16, Pic32 and so on) 2: Deleted the entire registry entry "HKEY_CURRENT_USER \ Software \ MatrixTSL \ FlowcodeV8" as well as SCADA. 3: Then...