Search found 3 matches

Return

by medelec35
Tue Oct 26, 2010 11:01 pm
Jump to forum
Jump to topic

Re: EB006 Multi Programmer QUESTION!!

Sorry typo I meant j3 not j5..like you said getting late and font is fairly small sorry about that. But you should not have 4.1Vdc on +V of terminal block J1, if you have then connection wire form programmer to LCD diisplay is open circuit or missing. Make sure wire is connected from +V of EB006 to ...
by medelec35
Tue Oct 26, 2010 12:09 pm
Jump to forum
Jump to topic

Re: EB006 Multi Programmer QUESTION!!

Hi there. In your previous post, You mentioned something about LVP programming. I checked the 'I/O output'/'LVP PROG' jumpers (labeled: J11, J16 and J17) on the EB006 Multi Programming board, and I noticed that they were all on the 'I/O Ouput' side. LVP PROG jumpers must all be on I/O Low voltage p...
by medelec35
Wed Oct 27, 2010 9:08 pm
Jump to forum
Jump to topic

Re: EB006 Multi Programmer QUESTION!!

Yes you are correct. You do need a wire going from +V on programmer to the +V on the the switch board. As previously stated most Ebocks require an external +5V connected to them via a wire form EB006 with the exception of LED Eblock. If you are not sure, then take a look at the data sheet for the Eb...