Search found 5 matches

Return

by DavidA
Thu Jan 05, 2012 1:27 pm
Jump to forum
Jump to topic

Re: Formula Flowcode connection

Hello, You can tell if your Buggy drivers are working properly by following these instructions. Firstly start the BuggyProg Tool by browsing to the Tools section within the Flowcode directory (normally C:\Program Files\Matrix Multimedia\Flowcode V4\Tools) and opening the BuggyProg.exe file. Next ope...
by DavidA
Fri Jan 06, 2012 4:14 pm
Jump to forum
Jump to topic

Re: Formula Flowcode connection

Hello, In Flowcode V3 the BuggyProg.exe is in the root of the Flowcode directory, not in the "tools" section. C:\Program Files\Matrix Multimedia\Flowcode V3\ From the looks of your installation path you are using Windows 7 32bit (this may be wrong and should be checked by going to Control ...
by Benj
Fri Jan 06, 2012 6:10 pm
Jump to forum
Jump to topic

Re: Micromouse maze solver using formula flowcode buggy

Hello, The formula flowcode robot does not have encoders attached to the motor outputs and this means you are driving the robot using dead reckoning meaning identifying when the robot has passed into a new cell will be tricky. You could maybe mark the maze with lines the line following sensors can s...
by DavidA
Fri Jan 06, 2012 5:17 pm
Jump to forum
Jump to topic

Re: Formula Flowcode connection

Hello,

yes the dpinst_x86 will work for all versions of windows XP upwards.
by DavidA
Mon Jan 09, 2012 4:52 pm
Jump to forum
Jump to topic

Re: Formula Flowcode connection

PMs sent and problem solved hopefully :)