Search found 9 matches

Return

by kersing
Wed Feb 26, 2014 10:06 pm
Jump to forum
Jump to topic

Re: FC4 and FC6 on the same PC

Installing and running both version on the same PC is no problem at all. I've got FC4, 5 and 6 on one system without issues.

You know you can download FC6 and test it for a month for free?
by Steve001
Thu Feb 27, 2014 8:42 am
Jump to forum
Jump to topic

Re: FC4 and FC6 on the same PC

i am also running V4, V5 free and V6 on the same pc with no apparent issues

Steve
by Benj
Mon Mar 17, 2014 11:03 am
Jump to forum
Jump to topic

Re: FC6 with PIC18F2420 EE-Prom Problem

Hello Dirk, I found a problem with the EEPROM on some 18F devices last week. Here is an updated chip definition file for the 18F2420 with the problem resolved. Place the attached file into your "Flowcode 6/FCD/PIC" folder before starting Flowcode to load in the changes. 18F2420.fcdx Let me...
by kersing
Mon Mar 17, 2014 1:21 am
Jump to forum
Jump to topic

Re: FC6 with PIC18F2420 EE-Prom Problem

One thing to try is to add a small delay (100ms to 1 s) to the start of your code. If that does not work, could you post a simple test flowchart we can take a look at?
by kersing
Mon Mar 17, 2014 12:30 am
Jump to forum
Jump to topic

Re: FC6 with PIC18F2420 EE-Prom Problem

Which eeprom location are you using? According to forum messages it's better to avoid using the first byte (0).
by kersing
Sun Mar 16, 2014 11:43 pm
Jump to forum
Jump to topic

Re: FC6 with PIC18F2420 EE-Prom Problem

Hi Dirk,

Please use "Check for Updates..." from the "Help" menu to update to 6.0.4.0, then test again.

Jac
by Benj
Thu Oct 02, 2014 10:44 am
Jump to forum
Jump to topic

Re: 4d OLED not working with FC6 and PIC18F2420

Hi Dirk,

There may be a subtle change, e.g. a new baud rate or new commands. I will add it to the list to investigate.
by LeighM
Mon Aug 17, 2015 8:30 am
Jump to forum
Jump to topic

Re: i2c slave

Hi Dirk,
The I2C CAL component now (since 6.1.0) supports the Slave feature and macros.
Regards,
Leigh
by Benj
Tue Nov 21, 2017 11:18 am
Jump to forum
Jump to topic

Re: UART with two differnt baudrates

Hello Dirk, Currently custom baud rates are not supported but you can add support for them by editing the CAL file. First copy the file "Flowcode 6\CAL\PIC\PIC_CAL_UART.c" to your desktop or another place where you can edit the file. Open the file using a text editor such as notepad. Near ...