Matrix user forums

Benj wrote:Here you go,

KEY_PAD_02.fcfx

Thank you so much Benj for the file, thats a big help for me.
Regards astro1234.

just tried that my self, and flowcode v7 does indeed crash.
regards astro1234

Wow just had shock when running flowcode v7, a have a icon on the quick start bar in windows v10 pro,(click once to run file) and by accident i clicked the icon twice, so two version of flowcode started to run, when i checked my licences none of my chipacks where registered (which is all of the pack...

i cannot get it to happen again,strange, panic over
Thanks for the quick reply.
Regards astro1234

Tried that out, would only work up to 255,
so changed the number format to int, and it works ok.
Thank you.
Regards Roy.

Hi Roy, I've noticed a couple of things. Your input read is converting the whole of PortB into an input which may be causing temporary issues on your motor drivers. The value of delay in the loop is going to set the speed for both motors. To solve the problem I used the switch components to allow m...

Downloaded the patch,after installing showing 8.02.12,so removed flowcode,
then downloaded the full install,now showing 8.2.13, seems to be ok.
Regards Roy.

Problem sorted, for some reason the first payment did not go through, so Matrix said to try again, This time went through ok (hope I don’t get billed twice.). All packs now activated. Also, would like to thank Matrix for extending BF2019 after 12pm for me, so I could get the discounts. So, ONE BIG T...

Thank you Benj,that sorted it out,now all working.
Regards Roy.