Matrix user forums

Hello,

We can find different packages of MIAC ( MIAC + Flowcode V3, MIAC+Flowcode V4, Miac + Flowcode V5 ..)
Is the hardware of the different packages are the same ?

Best regards

Bonjour, Je développe actuellement une application avec un module Miac . J'ai un FlowKit in-circuit debug system pour débugger mon application. Mon application se bloque après quelques minutes de fonctionnement . Lorsque je compile mon application sans activer le mode ICD (menu afficher/options proj...

Voici le fichier épuré...
Le problème vient de la présence de "code supplémentaire"
Je ne comprends pas pourquoi je n'ai pas de problème en compilation "normale" alors que j'ai des erreurs en compilation en "mode ICD"

"E-system design software"
To have a good translation, could you give use ,more détails, about this software ?

Bonjour, Je développe actuellement une application avec un module Miac . Je viens d'acheter un FlowKit in-circuit debug system pour débugger mon application. Lorsque je compile mon application sans activer le mode ICD (menu afficher/options projet), je n'ai pas d'erreur. Lorsque j'active le mode ICD...

Hello,
I have used the "Misc"/ "EEPROM" with Flowcode 4.
With this, we can write ans read the MIAC EEPROM.
Best Regards

Hello,
Thanks a lot
With : everything is OK.
Could you please transfer my question to V4 forums ? I can't do by myself.

Hello, I have a problem with the program test2.fcf The simulation is running well on my computer ( 22 is display), but when I transfer the the program in the MIAC, it display 0.0000 If I put : toto = 10.0 instead of : toto = 10.0 + 12.0 it running well on PC and MIAC (display : 10.00...) Where is th...

Hello,
Is the" I/O on the expansion modules" have been developped ?
Where can I see them ?
Best regards

Thank you One or 2 months is not a problem for me. My problem is not the number of analog input (1 need 3 analog input in my application), but the range (in V) and the filtering. It's a noisy electrical environnement, I need to respect Shannon condition : so I need to use filter before digital conve...

Hello, The Miac module is very well done (compact, small keyboard, display, lots of I/O ..). Flowcode is a very good graphics sofware for programming PIC. But I have problem, for my application, with I/O -> 3 solutions for me : create and use a extra module to adapt level, cut-off frequency to the M...

Hello,
For my application, it will be difficult to implement FIR filter.
So, I try to implement a hard low pass filter.
I've seen that there are two AZ324M-E1 near analog inputs.
Is-it use as low pass filter ? If yes, what is the cut-off frequency ?
Best regards

Thanks a lot for these informations.

Hello, I have baught a MIAC module, but I have some questions : I my application, I need to use analogic inputs. 1) Is there some analog low filter on analog input ? What is the cut-off fréquency ? 2) Do you have a équivalent circuit of the input ? Each MIAC input (I1—I8) represents a resistive load...