hi,
i want to program a Pi with the standard 7" touch screen that is available through the Pi Hut. i am using flow code V8 is there any examples programs available to use as a base starting point, that i could adapt.
cheers stuart
Search found 5 matches
- Mon May 22, 2023 10:25 am
- Forum: Flowcode V8
- Topic: Pi Touch screen programming
- Replies: 3
- Views: 14377
- Fri Mar 11, 2022 10:38 am
- Forum: Flowcode V8
- Topic: Run Out of Program Space on chip
- Replies: 1
- Views: 1928
Run Out of Program Space on chip
Hi, I have just compiled a project in V8 and have noticed i have used 100% Program space! I also get this message at the bottom of the compiler report. You have compiled in FREE mode. Using Omniscient Code Generation that is available in PRO mode, you could have produced up to 60% smaller and 400% f...
- Fri Oct 16, 2020 3:55 pm
- Forum: Flowcode V8
- Topic: storing eprom's when using a pi
- Replies: 1
- Views: 1145
storing eprom's when using a pi
is there a way of storing variables to an eprom address or similar so the pi can know what state the hardware was in after a power down?
- Fri Oct 16, 2020 1:04 pm
- Forum: Flowcode V8
- Topic: programming a micro from a set address
- Replies: 1
- Views: 1443
programming a micro from a set address
We were using flowcode v4 and loaded a boot loader on to the micro. then we load the main program to a set address so to not over write the bootloader. we have updated to V8 and cant find out how this is done in V8.
- Mon Sep 07, 2020 3:08 pm
- Forum: Flowcode V8
- Topic: Pi V 4
- Replies: 1
- Views: 1027
Pi V 4
I am trying to start a new project in V8 to work on a PI but the PI 4 is not listed?