Matrix user forums

Hi Leigh,

Sorry it is MIAC dsPIC V3 or something

Hi Team. Can you please help me ,is there anyway that I can link the MCP2515 CAN controller INT pin to one of the IOC pin s on the Micro , in a busy application polling the CAN bus results in a loss of messages, I am prepared to do the HW change myself but with out a schematic it is Risky affair P1....

Thanks Leigh
Appreciate it

Hi Team,
From the MIAC for Pic manual there is a nice table that shows the numbers returned from the keypad
as shown below

In the dsPIC manual there is no such information is there some info you can help me with
Thanks a million

Thanks Steve
I helped the man with the book so he is ok now

Leigh

Thanks now I know how to layout the wiring and connections the internal ESD TVS is not enough for sure

Hi Leigh

Can you also tell me please if there is TVS diodes on the front end of the Transceiver node to protect the transceiver ,as this MIAC will run in an noisy environment.

Thanks a million

Hi

Thanks Leigh

Hi Team,

Can you please advise me on using the dsPIC MIAC RS485 should I add the 120 Ohm terminator resistor or is this already included in the Hardware.

I did not find any reference in the manual regrading the terminators

Appreciate your input

Hi Team and friends in the Forum.

Merry Christmas and a happy new year !!

HI What does it mean: "Attach old Flowcode licenses to your account"? You should have registered your user account at the MATRIX web page ,This account you use for all your Licensing and product/component or chip pack keys.What this mean is if you have previously purchased Flowcode licenses you can ...

Hi LiamW,

Thank you this is indeed a good decision ,This is one of the reasons I have been with MATRIX a long time you people are always open to listen to your users,Great stuff and a big thumbs up.

Hi.

I am quite sure that there is no component to handle Flash writes however one of the forum users might have something to help you
as far as I know you can do it in a C code icon with C code

Hi All. I fail to see the reason behind PIC32/STM32 and DSP packs to be only available to PRO users (1) The world is moving very fast to 32 bits MCU and even today many private user are moving to 32 Bit ,Microchip has a full Arduino support package if you by a Microchip sketch like uC32, you can use...

The compiler is the same for both version, however the components are not. FC8 components are slightly larger and as a result more memory is required.

Thanks Kersing my feeling is still memory problem looking at the compiler message

Ok ,
not seeing the code we are only guessing

Hi.

There should be no difference between XC8 and XC8 in V7 and V8
My wild guess is you ran out of memory on the chip

This new V9 forum works fine with me
https://www.flowcode.co.uk/forums/

Hi
Hope this helps!

There is a dedicated FC V9 Forum here
https://www.flowcode.co.uk/forums/

Thanks Steve

Dear Team.

I must be honest for many years I am using the DSP component with my free version setup(PIC PIC16 and PIC32) and now
after so many years supporting you, I have to go to professional to upgrade my PIC32 and DSP ,

[Hi Ben
Thank you very much

Hi Team. I am having issue with a PIC16F648A and Ghost , It is inpossible to add a Analog trace to the Data Recorder Here you can see pins RA2 and RA 3 are set as Analog pins in Ghost this is done automatically by FC Gosht Select.jpg Trying to select the RA2 or RA3 as Analog pin in the recorder is n...

HI.

I would advise you to ask this at the Microchip forum ,People here work with Flowcode on PIC

Hi

I have send you an PM

Have good time