Interface Board

For E-blocks user to discuss using E-blocks and programming for them.

Moderators: Benj, Mods

Post Reply
lungchard
Flowcode v5 User
Posts: 19
Joined: Wed Aug 14, 2013 3:53 pm
Location: Thailand
Has thanked: 1 time
Been thanked: 3 times
Contact:

Interface Board

Post by lungchard »

Hello Matrix,
Have you considered making an interface PCB that will allow the user to mix and match the connections to an E-Block? This is useful when developing a idea but do not want to use the default E-Block connections.
I imagined something similar to what you have done on the EB005 board, only this board will be 2 ports wide and fit your development board.

Best Regards
Richard Hogan.

User avatar
JohnCrow
Valued Contributor
Valued Contributor
Posts: 1367
Joined: Wed Sep 19, 2007 1:21 pm
Location: Lincolnshire
Has thanked: 364 times
Been thanked: 716 times
Contact:

Re: Interface Board

Post by JohnCrow »

Hi Richard

Have you looked at the EB017 protoboard.
These are 2 ports wide, and very useful. Ive used these for several projects.

I built a multi sensor board using this, and also used it to design my own eblocks.

http://www.matrixmultimedia.com/mmforum ... f=2&t=7940
1 in 10 people understand binary, the other one doesn't !

lungchard
Flowcode v5 User
Posts: 19
Joined: Wed Aug 14, 2013 3:53 pm
Location: Thailand
Has thanked: 1 time
Been thanked: 3 times
Contact:

Re: Interface Board

Post by lungchard »

Thanks John for the reply.
I will check it out.

Best Regards

Richard.

Post Reply