Attached is a simple Flowchart that works on EB006 V7
Turning pot connected to PortA1 (An1) from min to max causes LCD to change from 0 to 255 as expected.
Connect hardware to EB006 V9 then send same flowchart then:
Turning pot connected to PortA1 from min to max causes LCD to change from 0 to 1 Not as expected!
When display is showing 1, the voltage measured on pin 3 of 16F1937 is 4.87V
Anyone else seeing this or is it just me?
What makes this even more odd is if I used a 16F1937 on Eb006 V7 ADC works fine.
If I use 16F877A in EB006 V9 ADC works fine.
So that's why I'm confused.
Martin
EB006 V9 ADC confusion. [SOLVED]
-
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
EB006 V9 ADC confusion. [SOLVED]
- Attachments
-
- ADC 16F1937 Test2.fcfx
- (5.59 KiB) Downloaded 231 times
Martin
- LeighM
- Matrix Staff
- Posts: 2178
- Joined: Tue Jan 17, 2012 10:07 am
- Has thanked: 481 times
- Been thanked: 699 times
- Contact:
Re: EB006 V9 ADC confusion.
Hi Martin,
That is odd, works OK on the EB006 V9 and 16F1937 I have.
Regards,
Leigh
That is odd, works OK on the EB006 V9 and 16F1937 I have.
Regards,
Leigh
-
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
Re: EB006 V9 ADC confusion. [SOLVED]
Thanks Leigh,
The issues was caused by a faulty ADC on the 16F1937 itself.
Reason why It appeared to work on a V7 programmer is I must have inadvertently placed my other target device in my old programmer as the chips were placed near each other.
Benj & I came to that conclusion this evening while Ben was testing all the possible scenarios.
Thanks for your help Ben it is appreciated.
Martin
The issues was caused by a faulty ADC on the 16F1937 itself.
Reason why It appeared to work on a V7 programmer is I must have inadvertently placed my other target device in my old programmer as the chips were placed near each other.
Benj & I came to that conclusion this evening while Ben was testing all the possible scenarios.
Thanks for your help Ben it is appreciated.
Martin
Martin