EB018 CAN board and PIC16F88

[Walbeek]

Hi there,

I want to connect the EB018 CAN board to a EB006 programmer with a PIC16F88 inserted.
According the datasheet, the 3-pin jumper is set on position B.
In FC6, CAN is connected as Channel 1, so SDI on pin RB1, SDO on pin RB2, SCK on pin RB4.
The Chip-select pin is set to RC6 but this is not available.
Where do I have to connect the CS pin of CAN?
Is every pin possible in the RB port?
Please let me know.

Rinie

[QMESAR]

The Chip-select pin is set to RC6 but this is not available.
Where do I have to connect the CS pin of CAN?

In my opinion you can use any open I/O pin for CS as long as you select the correct pin in the Component properties

[Walbeek]

Thanks QMESAR, seems to work well.
Tested on several pins now.