ECIO28P & ECIO40P

For E-blocks user to discuss using E-blocks and programming for them.

Moderators: Benj, Mods

User avatar
Steve001
Valued Contributor
Valued Contributor
Posts: 1062
Joined: Wed Dec 31, 2008 3:37 pm
Has thanked: 435 times
Been thanked: 484 times
Contact:

ECIO28P & ECIO40P

Postby Steve001 » Thu Mar 30, 2017 7:34 pm

Evening All

is there a clearer diagram for the ecio modules?

Downloaded a product data sheet ref ECIO-60-2 and the diagrams are not very clear can zoom to around 150 % ish and the text is a bit better but still hard to read

Steve
Attachments
ECIO-60-2 page 3 .JPG
ECIO-60-2 page 3 .JPG (71.94 KiB) Viewed 3267 times
Success always occurs in private and failure in full view.

User avatar
LeighM
Matrix Staff
Posts: 1766
Joined: Tue Jan 17, 2012 10:07 am
Has thanked: 417 times
Been thanked: 582 times
Contact:

Re: ECIO28P & ECIO40P

Postby LeighM » Thu Mar 30, 2017 10:02 pm

Hi Steve,
As I recall, the pinout is available on the Chip view for the target in Flowcode, if that helps.
Not that I can check at the moment, not on this tablet, yet :)
These users thanked the author LeighM for the post:
Steve001 (Fri Mar 31, 2017 12:47 pm)
Rating: 5.88%
 

User avatar
Benj
Matrix Staff
Posts: 13980
Joined: Mon Oct 16, 2006 10:48 am
Location: Matrix TS Ltd
Has thanked: 4244 times
Been thanked: 4006 times
Contact:

Re: ECIO28P & ECIO40P

Postby Benj » Fri Mar 31, 2017 9:53 am

This datasheet shows the chips a bit clearer.

ECIO-60-4.pdf
(2.15 MiB) Downloaded 221 times
These users thanked the author Benj for the post (total 3):
JohnCrow (Fri Mar 31, 2017 10:25 am) • medelec35 (Fri Mar 31, 2017 11:21 am) • Steve001 (Fri Mar 31, 2017 12:42 pm)
Rating: 17.65%
 

User avatar
Steve001
Valued Contributor
Valued Contributor
Posts: 1062
Joined: Wed Dec 31, 2008 3:37 pm
Has thanked: 435 times
Been thanked: 484 times
Contact:

Re: ECIO28P & ECIO40P

Postby Steve001 » Fri Mar 31, 2017 12:43 pm

cheers Ben

Leigh forgot about that option

Steve
Success always occurs in private and failure in full view.