EB to EB2 (BL0113-1)
Posted: Fri Nov 09, 2018 4:50 pm
Hello,
I have a problem with connecting the Eblocks2-module to the Eblocks-board using an EB to EB2 adapter (BL0113-1).
The adapter has three sockets (+V, 3V3, 5V) for wired connection, but hasn't ground socket (marked on the board as GND).
I looked in the description of the BL0113 component, and there it says that the ground is on the outer part of the adapter.
So I connected the wire to the hole near Eblocks port of adapter, but this does not work.
May I know how to properly connect the Eblocks2-module to the Eblocks-board using an EB to EB2 adapter?
Thanks in advance for the answer.
I have a problem with connecting the Eblocks2-module to the Eblocks-board using an EB to EB2 adapter (BL0113-1).
The adapter has three sockets (+V, 3V3, 5V) for wired connection, but hasn't ground socket (marked on the board as GND).
I looked in the description of the BL0113 component, and there it says that the ground is on the outer part of the adapter.
So I connected the wire to the hole near Eblocks port of adapter, but this does not work.
May I know how to properly connect the Eblocks2-module to the Eblocks-board using an EB to EB2 adapter?
Thanks in advance for the answer.