problem working with internal oscilator

Any general or miscellaneous queries that do not fit into the other forum catagories

Moderators: Benj, Mods

hazic
Posts: 24
Joined: Tue Jan 05, 2010 8:59 am
Been thanked: 1 time
Contact:

problem working with internal oscilator

Postby hazic » Sun Aug 01, 2010 6:32 am

Hi
I'm trying to use the internal oscilator of the ATtiny2313
I compiled a simple program for test that switching a LED on and off every 1 second delay and I programmed it to the chip using AVRstudio after setting the fuse to internal oscilator 8mhz
and while it run the LED is switching every about 8 seconds...
should I change somethng in the settings of flowcode?

hazic
Posts: 24
Joined: Tue Jan 05, 2010 8:59 am
Been thanked: 1 time
Contact:

Re: problem working with internal oscilator

Postby hazic » Sun Aug 01, 2010 7:09 am

OK I disabled the CKDIV8 fuse and I think it's working good now!
but just to be sure, is there any configurations I need to make in the flowcode when I change the osilators?