Programmer Error

Forum for problems or queries regarding the Flowcode application and compiler usage.

Moderators: Benj, Mods

Post Reply
spence
Posts: 11
Joined: Wed Dec 10, 2008 7:42 pm
Contact:

Programmer Error

Post by spence »

Ben

I have a programmer that has been used to burn 2 chips It no longer works for some reason says No USB connection (slot0)

Cable and ports are both fine any ideas

Cheers
Spence

User avatar
Benj
Matrix Staff
Posts: 15312
Joined: Mon Oct 16, 2006 10:48 am
Location: Matrix TS Ltd
Has thanked: 4803 times
Been thanked: 4314 times
Contact:

Re: Programmer Error

Post by Benj »

Hello Spence

Is it our hardware your using. Have you tried the USB power management workaround detailed here.

http://www.matrixmultimedia.com/support ... .php?t=509

Also make sure that the jumper settings are still correct. Eg USB/PSU jumper set to PSU and USB/ICD jumper set to USB.

If none of the above works then is the device showing up in device manager and also is the orange LED lighting when the USB is plugged in.

Post Reply