Changing Target
Posted: Wed Jan 21, 2009 9:59 am
I have a flowcode program debugged and working in the 16F84.
I now wish to load it into a 16F88.
To do this I select the 16F88 in the Chip - Target menu of flowcode. It compiles and saves fine.
The target select screen dump is attached.(ChipError#1.jpg)
When I compile to chip, I get an error saying that the inboard chip is a 16F88 (correct) but the selected target is a 16F84 ( incorrect, I changed it above ). See attached ChipError#2.jpg.
I tried using PPP, and when I started it up it had 16F84 as the target. ( See attached ChipError#3.jpg). So I changed the target to 16F88 as required and downloaded the hex file to the chip. It went in fine and the program runs as expected.
I thought this may be the porblem, so tried downloading again from Flowcode, but still get the target selection error.
Any ideas?
Thanks
Andrew Osborn
I now wish to load it into a 16F88.
To do this I select the 16F88 in the Chip - Target menu of flowcode. It compiles and saves fine.
The target select screen dump is attached.(ChipError#1.jpg)
When I compile to chip, I get an error saying that the inboard chip is a 16F88 (correct) but the selected target is a 16F84 ( incorrect, I changed it above ). See attached ChipError#2.jpg.
I tried using PPP, and when I started it up it had 16F84 as the target. ( See attached ChipError#3.jpg). So I changed the target to 16F88 as required and downloaded the hex file to the chip. It went in fine and the program runs as expected.
I thought this may be the porblem, so tried downloading again from Flowcode, but still get the target selection error.
Any ideas?
Thanks
Andrew Osborn