Page 1 of 1
Flowcode V3 & PIC12F510
Posted: Sat Aug 22, 2009 2:00 pm
by mfun
Hello,
Why is a PIC12F510 offered as a target in V3, but not supported under configuration?
Regards,
Mike
Re: Flowcode V3 & PIC12F510
Posted: Sat Aug 22, 2009 2:14 pm
by Benj
Hello Mike
Which version of Flowcode are you using? As far as im aware the 12F510 device was removed from Flowcode a long time ago. BoostC has even dropped it from its supported device list.
Re: Flowcode V3 & PIC12F510
Posted: Fri Aug 28, 2009 3:58 pm
by mfun
Hi Benj,
As I stated earlier...(twice)- V3 is the version.
It is still listed as a possible target.
Regards,
Mike
Re: Flowcode V3 & PIC12F510
Posted: Tue Sep 01, 2009 4:20 pm
by Benj
Hello Mike
Sorry which version of V3. Eg 3.0, 3.1, 3.4, 3.6, etc.
V3.6 can be downloaded from here if you are using an older version.
http://www.matrixmultimedia.com/Flowcode3a-X.php