MIAC MI3846 - Advanced expans + Flowcode 7 and Oxygen sensor

[go233]

Hello,
could you recommend an air oxygen sensor that works with the MIAC MI3846 - Advanced expansion module.
(In my application I need to check continuously the percentage of O2 in the air for safety reasons)
MIAC+MI3846+suggested oxygen sensor can be programmed with flowcode 7? does it have any macro developed for it?
(I guest MI3846 - Advanced expansion module is not supported in flowcode 6)
Thanks
Givoanni

[Benj]

Hello,

There is this O2 sensor from Vernier which is compatible with the sockets on the MI3486 Advanced module.
http://www.vernier.com/products/sensors/o2-bta/

The sensor will likely just return an analogue value so you just need to use the sensor manual to calibrate the sensor and configure your calculations.

[Steve001]

Hi Givoanni

Have you looked at Honeywell - they wont be cheep though

http://sensing.honeywell.com/honeywell- ... 4294956300

you may have to include an amplifier as most are mv output's



find your local reseller here

https://sensing.honeywell.com/global-sales-and-service


Steve