Hello everyone
For MIAC type MI5466 ATmega.
Just bought 1 pc. Arduino compatible for MIAC
Can not upload codes from FlowCode V7 to MIAC!
How can I upload codes from FlowCode V7 to MIAC? Like to refer to a Web link.
Where can I download driver for MI5466 ATmega?
Have tried but get the following message: Device Driver Prog Breastfed was not installed?
User:
Flowcode V7
Windows 7 64 Bit
Upload codes from FlowCode V7 to MIAC
-
- Posts: 484
- Joined: Mon Jul 30, 2012 3:39 pm
- Has thanked: 17 times
- Been thanked: 46 times
- Contact:
- LeighM
- Matrix Staff
- Posts: 2178
- Joined: Tue Jan 17, 2012 10:07 am
- Has thanked: 481 times
- Been thanked: 699 times
- Contact:
Re: Upload codes from FlowCode V7 to MIAC
Hi Monie,
Does your windows PC detect the MIAC USB when it is plugged in?
Windows should install the required drivers.
If it does not, please download and install the FT230X VCP drivers from http://www.ftdichip.com
http://www.ftdichip.com/Drivers/VCP.htm
I have attached our draft help guide.
Let me know how you get on,
Regards
Leigh
Does your windows PC detect the MIAC USB when it is plugged in?
Windows should install the required drivers.
If it does not, please download and install the FT230X VCP drivers from http://www.ftdichip.com
http://www.ftdichip.com/Drivers/VCP.htm
I have attached our draft help guide.
Let me know how you get on,
Regards
Leigh
- Attachments
-
- HP0819 MIAC Flowcode Getting Started Guide.pdf
- (1.77 MiB) Downloaded 412 times
-
- Posts: 484
- Joined: Mon Jul 30, 2012 3:39 pm
- Has thanked: 17 times
- Been thanked: 46 times
- Contact:
Re: Upload codes from FlowCode V7 to MIAC
Hello LeighM
Many, many thanks for your help.
It worked fine with your referred driver.
GO'Weekend
Many, many thanks for your help.
It worked fine with your referred driver.
GO'Weekend
Best Regard
Monie
Monie