Why not:Flowcode USB serial

[nnnnff]

I want to make a single chip microcomputer and computer communication experiment USB, but USB serial driver installation is always a mistake. As shown in figure. Please help me. Thank you!

[Benj]

Hello,

Have you generated the driver from the USB component properties and then used this driver when installing the USB serial device in device manager?

[nnnnff]

Yes! Generate and install! As shown in figure。But always not line! Why?

[Benj]

Hello,

Please can you post up your Flowcode program too and I will have a look through that to see if I can spot anything.

Have you managed to get any USB comms working or are you just starting out with it from one of the example files?

[nnnnff]

One example. The simulation is good. Download to chip can't run. And put the computer, can't find new hardware. So the driver installation not line! Thank you, help me!

[Benj]

Hello,

I have offered a solution to the problem here.
http://www.matrixmultimedia.com/mmforum ... 29&t=10801

Let me know how you get on.