Automotive PSU

For users of Matrix Multimedia Electronics software to discuss projects, circuits and any other electronics concepts.

Moderators: Benj, Mods

Post Reply
Docara
Posts: 315
Joined: Sun Jun 23, 2013 1:29 pm
Has thanked: 28 times
Been thanked: 61 times
Contact:

Automotive PSU

Post by Docara »

Hello Everyone and Happy New Year,

It looks like I need to put a microcontroller into a marine (diesel automotive) environment.

Does anyone have any actual hands on experience with automotive PSU's and could give me some advice how to implement a reliable uP supply? Ideally I need 3.3V and 5V @1A max

What I have in place at the moment is not the usual configuration but a dual battery bank setup with latching power relays to disconnect, isolate or bridge the banks as the charge level dictates, so I foresee some nasty switching spikes floating around.

My initial thoughts were to use suitable TVS's and some inductors feeding a linear power supply (automotive grade 7805 or similar). Looking around the net I found this LTC3895 http://cds.linear.com/docs/en/article/P ... ession.pdf (which looks great) which addresses all my concerns but I don't have the PCB board making facilities or soldering capabilities to do the under-chip soldering required - I have Veroboard and that's it.

Thanks
MAtt

User avatar
Steve001
Valued Contributor
Valued Contributor
Posts: 1189
Joined: Wed Dec 31, 2008 3:37 pm
Has thanked: 460 times
Been thanked: 523 times
Contact:

Re: Automotive PSU

Post by Steve001 »

Hi Matt

What's the input voltage ?

We use DCDC convertors at work for a lot of our products Both standard and railway spec (these are more expensive but have more filtering)

have a look at traco or xp power

https://www.tracopower.com/products/bro ... onverters/

https://www.xppower.com/Products/DC-DC- ... Hole-Mount

this is not a bad device

https://www.tracopower.com/products/ten8wi.pdf


Hope this helps

Steve
Success always occurs in private and failure in full view.

Docara
Posts: 315
Joined: Sun Jun 23, 2013 1:29 pm
Has thanked: 28 times
Been thanked: 61 times
Contact:

Re: Automotive PSU

Post by Docara »

He Steve,

Good to here from you again.

Yeah 12Vdc nominal and I think 14.4Vcd charge possibly upto 15.2V - (I cant remember if AGM's have a maintenance de-sulphuring 15.2Vdc type cycle)

I will have a look at the links now

Matt

Post Reply