Flowcode does not simulate 7seg LEDs correctly.

Moderator: Benj

Post Reply
medelec35
Matrix Staff
Posts: 9520
Joined: Sat May 05, 2007 2:27 pm
Location: Northamptonshire, UK
Has thanked: 2585 times
Been thanked: 3815 times
Contact:

Flowcode does not simulate 7seg LEDs correctly.

Post by medelec35 »

Unless i am doing somthing wrong :P
When using two 7seg0 LEDs, both 7seg0 LEDs are lit when only one 7seg0 LED is enabled. E.g if led7seg1 only is enabled first then only led7seg1 will bit lit. when stepping through simulation and led7seg1 ClearDigit is used and it goes out, then when led7seg0 only is enabled both led7seg1 and led7seg0 light at the same time
For an example Flowchart see:
http://www.matrixmultimedia.com/mmforum ... =29&t=7795
Flowchart is called: 7Seg_Test Modified.fcf and is attached to 5th post down.
Martin

Post Reply