Keith Sloan

For anyone wishing to receive additional help with a project or simply looking to hire an embedded contractor we have a few contacts who would be more then willing to help.

Moderators: Benj, Mods

Post Reply
KeithSloan
Posts: 114
Joined: Fri Jul 27, 2007 10:50 am
Been thanked: 1 time
Contact:

Keith Sloan

Post by KeithSloan »

Keith Sloan Bsc(hons) Electronic Science - over 30 years in IT industry

Have implemented a number of PIC projects
- Slot Car Lap Counter & Timer
- Infra Red Nikon Camera Trigger
- Read I2C Ultrasonic Range Finder & Displayed Values

All in MPLAB PIC Assembler. Very Interested in expanding experience - like I am
experienced C programmer but not so far with PIC .
Very reasonable rates
Winchester Area - Hampshire

Mark1
Posts: 1
Joined: Wed Jul 07, 2010 8:58 am
Contact:

Re: Keith Sloan

Post by Mark1 »

Hi Keith

we have a number of pic ASM programs we would like to convert to flow code if you can help please contact me

regards
mark

dswheeley
Posts: 10
Joined: Tue Mar 20, 2012 9:35 am
Contact:

Re: Keith Sloan

Post by dswheeley »

Hi David

I hope you do not mind I got your details from the Flowcode forums.

I am using a PIC16F639 or PIC16F636 which is an 125 KHz LF enabled micro controller. We are quite competent in flowcode, but not sure where to start with this device. We have ASM for the device, but not sure which parts to cut and paste to make a flow code module for the device.

I am looking for someone just to cut and paste the LF aspects of the ASM that we have into a flowcode ASM module. Is this something that you could help with.

Best Regards

Darren

Post Reply