RC5 Don't work!
RB0、RB1 no output。
help me.
Why RC5 Don't work?
Moderator: Benj
- Enamul
- Posts: 1772
- Joined: Mon Mar 05, 2012 11:34 pm
- Location: Nottingham, UK
- Has thanked: 271 times
- Been thanked: 814 times
- Contact:
Re: Why RC5 Don't work?
Hi
Can you please try this post of Martin? This is simple and easy to test.
http://www.matrixmultimedia.com/mmforum ... RC5#p45205
Can you please try this post of Martin? This is simple and easy to test.
http://www.matrixmultimedia.com/mmforum ... RC5#p45205
-
- Posts: 438
- Joined: Mon Aug 29, 2011 12:26 am
- Location: arizona
- Has thanked: 175 times
- Been thanked: 173 times
- Contact:
Re: Why RC5 Don't work?
are you using the current version of flowcode? if not what happens is it outputs on A0, in v5.5 the pin assignment was fixed
i use rc5 and its awesome
i use rc5 and its awesome
-
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
Re: Why RC5 Don't work?
What component are you using for your IR receiver.
You can't use an ordinary IR diode.
You must use a dedicated IR receiver with a 38KHz carrier frequency so any LED signals above and below 38KHz are rejected.
E.g
http://uk.farnell.com/vishay/tsop4838/i ... dp/4913190
or
http://www.radioshack.com/product/index ... Id=2049727
etc.
You can't use an ordinary IR diode.
You must use a dedicated IR receiver with a 38KHz carrier frequency so any LED signals above and below 38KHz are rejected.
E.g
http://uk.farnell.com/vishay/tsop4838/i ... dp/4913190
or
http://www.radioshack.com/product/index ... Id=2049727
etc.
Martin