Hello All,
I have a sensor that provide datas through CAN-BUS (NMEA 2000 to be precise).
I'd like to start reading the data on the bus but as I have never really done anything with CAN BUS is new to me.
I understand the CAN-bus principle, however, I'd like to get some feedback on how to physically connect the BUS to a PIC as well as
how to use the CAN-BUS Macro in FC5.
is there a tutorial on this subject?
Thanks
henk
CAN Bus for a beginner
Moderator: Benj
-
JohnCrow
- Valued Contributor
- Posts: 1367
- Joined: Wed Sep 19, 2007 1:21 pm
- Location: Lincolnshire
- Has thanked: 364 times
- Been thanked: 716 times
- Contact:
Re: CAN Bus for a beginner
Hi Henk
The easiest way to use FC and Microcontrollers is the Can-Bus Eblock
http://www.matrixmultimedia.com/product ... PHPSESSID=
There are some examples on the page too
The easiest way to use FC and Microcontrollers is the Can-Bus Eblock
http://www.matrixmultimedia.com/product ... PHPSESSID=
There are some examples on the page too
1 in 10 people understand binary, the other one doesn't !
-
Steve001
- Valued Contributor
- Posts: 1189
- Joined: Wed Dec 31, 2008 3:37 pm
- Has thanked: 460 times
- Been thanked: 523 times
- Contact:
Re: CAN Bus for a beginner
There is the learning center too
http://www.matrixmultimedia.com/lc_inde ... rder=&dir=
The teachers notes are very good
Steve
http://www.matrixmultimedia.com/lc_inde ... rder=&dir=
The teachers notes are very good
Steve
Success always occurs in private and failure in full view.
-
henker
- Posts: 45
- Joined: Mon Dec 22, 2008 11:22 pm
- Location: Prospect, NS, Canada
- Has thanked: 7 times
- Been thanked: 2 times
- Contact:
Re: CAN Bus for a beginner
When googeling, found this....
http://www.matrixmultimedia.com/mmforum ... =26&t=7375
kind of answer my question so I should be able to get started with this.
http://www.matrixmultimedia.com/mmforum ... =26&t=7375
kind of answer my question so I should be able to get started with this.