Hello all. Cant seem to burn my program to the 16F690 chip. Compiles to C and Hex all OK.
I have attached a screen grab of the error message and also of my chip settings. Hopefully somebody will spot my mistake.
Thanks a lot folks...........John
Wont Burn Program to 16F690 Chip
Moderator: Benj
-
- Posts: 271
- Joined: Tue Mar 05, 2013 10:49 pm
- Has thanked: 111 times
- Been thanked: 13 times
- Contact:
Wont Burn Program to 16F690 Chip
- Attachments
-
- IRTRIGGER.fcf
- (16 KiB) Downloaded 245 times
-
- NEW CHIP CONFIG SETTINGS2.jpg (61.73 KiB) Viewed 3513 times
-
- Burn To Chip Error2.jpg (44.5 KiB) Viewed 3513 times
-
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
Re: Wont Burn Program to 16F690 Chip
Hi John,
The usual cause of the error messag eyou can see are poor connections between Programmer and microcontroller.
Or there is a cap between programming connections and ground.
Have you got a circuit diagram?
You can check voltage are correct at each programming pin, by using the Pickit2 standalone programming software and going to Tools, Troubleshoot....
Martin
The usual cause of the error messag eyou can see are poor connections between Programmer and microcontroller.
Or there is a cap between programming connections and ground.
Have you got a circuit diagram?
You can check voltage are correct at each programming pin, by using the Pickit2 standalone programming software and going to Tools, Troubleshoot....
Martin
Martin
-
- Posts: 271
- Joined: Tue Mar 05, 2013 10:49 pm
- Has thanked: 111 times
- Been thanked: 13 times
- Contact:
Re: Wont Burn Program to 16F690 Chip
Ok I'll see if I can do that and do another post........Thanks John
-
- Posts: 271
- Joined: Tue Mar 05, 2013 10:49 pm
- Has thanked: 111 times
- Been thanked: 13 times
- Contact:
Re: Wont Burn Program to 16F690 Chip
Hi Martin, it looks like something has gone wrong with my PICkit2 programmer. I think its software so I'll reinstall it tomorrow and let you guys know what happens..
Thanks for your time..John
Thanks for your time..John