Page 1 of 1

MPLAB Check Sum

Posted: Wed Aug 21, 2019 10:25 pm
by Collimare
When I compile to hex where is the checksum?

When I program I still do not see the checksum?

I need to have our program preloaded into the microchip but need the checksum for the board stuffing house.

Re: MPLAB Check Sum

Posted: Thu Aug 22, 2019 9:47 am
by Benj
Hello,

If you download and install the latest MPLABX and include the IPE software during the installation. Then run the IPE software and load your .hex file then it will calculate the checksum for you.

IPE.jpg
IPE.jpg (126.29 KiB) Viewed 312 times

Re: MPLAB Check Sum

Posted: Fri Aug 23, 2019 12:56 am
by Collimare
Hi Benj, Thank you very much for the information. It worked perfectly.

Have a good one. Howard