Good morning
This is my first post on this board. I'm currently working on a CAN based project (pic18f4685). My software is working correctly.
My question is how could I do to have the CAN frames in the " Consoles Windows".
In fact currently my way to check my frames is to burn a chip and to plug a CAN analyzer. But is it possible to check this in Flowcode ? Without burn a chip everytimes.
Thanks in advance.
DK
how to use "Consoles Windows"
Moderator: Benj
-
JonnyW
- Posts: 1230
- Joined: Fri Oct 29, 2010 9:13 am
- Location: Matrix Multimedia Ltd
- Has thanked: 63 times
- Been thanked: 290 times
- Contact:
Re: how to use "Consoles Windows"
Hi Duke.
I am not sure about the particulars of the CAN, but there is nothing stopping this currently. If it does not already work like that then perhaps Ben or Leigh can put something together for it. I can certainly add it to our to-do lists and see what the outcome is.
Jonny
I am not sure about the particulars of the CAN, but there is nothing stopping this currently. If it does not already work like that then perhaps Ben or Leigh can put something together for it. I can certainly add it to our to-do lists and see what the outcome is.
Jonny