PicKit3 Command Line Extensions - Power
Posted: Tue Jun 10, 2014 7:05 pm
I have had a look at the excellent wiki
(and trawled the Forum, so sorry if it already there).
http://www.matrixtsl.com/wiki/index.php ... ming_Tools
and at the microchip datasheet (attached).
From this I expected changing, the FC 6 Programmer Parameters to:
-P$(chip) -F$(target).hex -E -M -V5.000
would give 5v power, no luck FC gives error 5 (vs error 2 for unpowered).
How can I power the PicKit3 when using FC6?
Thanks.
ps I'm using windows 7, 64 bit
(and trawled the Forum, so sorry if it already there).
http://www.matrixtsl.com/wiki/index.php ... ming_Tools
and at the microchip datasheet (attached).
From this I expected changing, the FC 6 Programmer Parameters to:
-P$(chip) -F$(target).hex -E -M -V5.000
would give 5v power, no luck FC gives error 5 (vs error 2 for unpowered).
How can I power the PicKit3 when using FC6?
Thanks.
ps I'm using windows 7, 64 bit