Ghost EB006V9

[henryscott]

Hallo,
I have just buied Flowcode 6 FC6PICCP for PIC.
For me is important to interface it with Ghost EB006V9 , I do not understand if it really work with the Flowcode6 Block I ordered. I have buied it, for debugging with it and the Picoscope.

I do not know if it can be interfaced with the Flowcode6 .

thank you

[Benj]

Hello,

The EB006 will work fine with Flowcode 6 and a PIC chip pack to program the microcontroller and allow it to run.

If you want the additional Ghost features of the EB006 such as ICD and ICT then you will require an additional Professional license for Flowcode.

[henryscott]

Hello,
and about the Flowcode Softscope , or other simulation?

Thanks
Henry

[Benj]

Hi Henry,

The information your after is shown on this page: http://www.matrixtsl.com/flowcode/buy/

The simulation will run on any version of Flowcode, however you only get the Scope and Console windows when using a Pro licence.

[henryscott]

hi Benj,

on http://www.matrixtsl.com/flowcode/buy/ I see ICT is included in my PIC Pack, is it real? I see, on ICT definitions, with the EB006v9 I have buied, I am able to make the ICT. Is it right?
Thanks
Henry

[Benj]

Hi Henry,

I've just seen the table and there are some blatant mistakes on there which I have asked to be fixed ASAP.

ICT relies on the Scope and Console windows to show the real time data and so I don't think you will have much luck without a Pro license.

ICD is completely missing from the list but also requires a Pro license.

[henryscott]

Hi Benj,
I see, but really I have buied this Flowcode6 and the EB006V9 , because I have seen ICT is in my package, by the table I seen before to buy it.
At now I need, you say to me, the professional license, so its out of my budget, really I see it's £ 220.00 more.
Maybe is possible a special commercial quote for the Professional, but I do not know if it is possible. I have no solution at now, with my Flowcode6 and EB006V9.
thank you, best regards
Henry