Hi Ben
Have received 2 TRX433S transceiver modules. Looking at the properties of the SRF component I see that the Tx and Rx pins are automatically selected according to the PIC chosen. Does this mean that the SDI pin of the radio module becomes the Rx pin and also the SDO the Tx?? Which is the ENABLE pin?
It is quite daunting to figure these radio modules and the relevant pin connections to the PIC16F690 mcu out as a novice, and the SRF help page is also very basic..!!
Are there no example programs available so as to learn from?
Thanks for your help, it is greatly appreciated.
Regards
Ted
TRX433S Module
Moderator: Benj
-
- Valued Contributor
- Posts: 2045
- Joined: Wed Aug 27, 2008 10:31 pm
- Location: Netherlands
- Has thanked: 553 times
- Been thanked: 1081 times
- Contact:
Re: TRX433S Module
Ted,
SDI and SDO are SPI interface, RX and TX serial interface. My guess is you need to use the EB063 component, not SRF.
I just noticed you asked the same question twice and Ben already replied. Please don't create multiple messages with the same question as it wastes our time...
SDI and SDO are SPI interface, RX and TX serial interface. My guess is you need to use the EB063 component, not SRF.
I just noticed you asked the same question twice and Ben already replied. Please don't create multiple messages with the same question as it wastes our time...
“Integrity is doing the right thing, even when no one is watching.”
― C.S. Lewis
― C.S. Lewis