Can't download the program to the hardware

[lahieb abrahim]

Dear
The program for 16f1826 is working fine in the software, once I download it I received a message:
Version 3.3.0.9
Board Type: EB006 v5-8
IsOpen : no
ID from Board: -1
Chip CmdLine:
USB Hardware: USB\VID_12BF&PID_0020&REV_0202
USB Description: Matrix PICmicro Programmer
ADCval: 2.68751E-317
Location: FileTypeS19.cpp @ 304 (FileTypeS19::Load)

EDIT: Is there any specific subject related to this issue? I can't read all of it please.

[EtsDriver]

Reading from your post, i would firstly check out the EB006 boards power jumpers (are they on extrenal power or on USB), as the ID readed from the board is -1, that could mean its not getting power.

[lahieb abrahim]

The problem I can't compile even the Hex file, it shows me this message:
Error: Failed to open:LCDtest.obj

[Benj]

Hello,

Please can you show us the complete compiler messages. or attach the .msg.txt file from the Flowcode project folder so we can see what's going wrong. The Flowcode project may also be useful if there are things in the causing the compilation error.

Which version of the EB006 programmer do you have. The version is shown on the board in the format EB006-00-X where X is the version number.