$PortA Settings
Posted: Sat Oct 27, 2018 5:14 pm
Hello All
Before I go back to the 1 for 1 settings I though I better see if anyone has a explanation on what is happening
I had individual port settings for A1-A7 starting off with a Logic 1.
I then though I could send $PortB = 11111110 and A1 - A7 should be set to Logic 1
It worked on A1..A2..A6...A7
I set A3 that wouldn't use the $PortB Settings back to A3=1 and it worked.
I even set A3 in the Port settings to 0 then back to 1 no luck.
John
Before I go back to the 1 for 1 settings I though I better see if anyone has a explanation on what is happening
I had individual port settings for A1-A7 starting off with a Logic 1.
I then though I could send $PortB = 11111110 and A1 - A7 should be set to Logic 1
It worked on A1..A2..A6...A7
I set A3 that wouldn't use the $PortB Settings back to A3=1 and it worked.
I even set A3 in the Port settings to 0 then back to 1 no luck.
John