Page 1 of 1
AVR Crash - Resolved
Posted: Fri Aug 16, 2013 6:41 pm
by JohnCrow
When I try to save an AVR flowchart (Any device)
I get the following message
- AVR_Crash.jpg (28.92 KiB) Viewed 7599 times
It seems to save the file, but if I try to open it I get the messge
Failed to open document
Attribute <Data> is not found
Arduinos will save though.
Re: AVR Crash
Posted: Fri Aug 16, 2013 7:23 pm
by dazz
Hi John
seems to save and open fine on my system (device) attached was one i did after your post to check (attached)
Regards
Dazz
Re: AVR Crash
Posted: Sun Aug 18, 2013 9:23 pm
by JonnyW
Hi John.
Is there anything you add to the project, or can you create a completely blank project and get this message (I notice there are some component calls in the background).
Can you post a corrupted file - whereabouts in the file it fell down may give a clue as to what is happening (though its a long shot).
Jonny
Re: AVR Crash
Posted: Mon Aug 19, 2013 3:12 pm
by JohnCrow
Hi Jonny
I put one in my other post yesterday about not been able to compile other devices
At work at the moment. Will try a blank project tonight
Re: AVR Crash
Posted: Mon Aug 19, 2013 6:20 pm
by JohnCrow
Hi Jonny
Tried saving a blank flowchart, get the same results.
Re: AVR Crash
Posted: Mon Aug 19, 2013 6:55 pm
by JonnyW
Excellent, thats caught it I think. There was a problem storing the config data - I think that will have fixed a couple of other strange config storage issues too.
Should be fixed in the next release.
Jonny