Benj wrote:Looks like I need to rig up a working circuit so I can sign off the code.
Here are the updated examples using the latest component with the address in place. Fingers crossed this works. If not then let me know and I will try and do some further tests here.
Thinking about it I have been misdirected by the Arduino code, setting the address as 5 individual bytes would be much easier then passing in an array!
I have flashed these charts into a PIC 16F877A.
Connected the modules onto them (with 3.3V power and the 5V tolerant to the PIC's).
For some reason I suspect the RX Flowchart from being faulty.
I've put LCD messages into the different steps to get feedback from the PIC to where the error occurs.
After the initialise I get a number 83 as an acknowledge back, so this means the module is initialised properly?
In the branch where no message is received I've put a message "No radio" but he never displays this message.
The program always follows the branch where the data is available.
Also when I switch off the TX module.
So I guess there is something wrong with the "Available" function?
BenJ, does this Flowchart work over there?
When I started the TX-module I saw that some features dimmed, so in my opinion this means that the TX module uses a lot of current, so this one works?