Page 1 of 1

CAN bus filter selection easier

Posted: Thu May 14, 2015 8:24 pm
by EtsDriver
You had some kind of mask calculator in V4/V5?
CAN solution Teachers notes wrote:25.2.4 The Details dialog
As Masks and Filters are quite complex, so we have included a dialog that displays which Message
ID's will be accepted given the current mask and filter settings for that buffer. To open the Details
dialog click on the Details button on the RX Buffer tabs.


Figure 25.1 The dialog shows the Mask and Filters values, and the Message ID's that each Filter
will accept

If a Filter is not enabled then the text "Filter Disabled" will be shown instead. The Buffer RX1 dialog is
similar to the Buffer RX0 dialog shown above, but with boxes for the four filters on that buffer.
How hard could it be to get it back to the FC6?

Re: CAN bus filter selection easier

Posted: Wed May 20, 2015 12:27 pm
by Benj
Thanks for the suggestion, I have added it to the list.

Re: CAN bus filter selection easier

Posted: Wed Mar 16, 2016 7:19 pm
by EtsDriver
Any news about this? :)