Hi guys.
I'm making a macro to run PWM Half-Bridge and you can adjust the period, dutycycle and deadband.
I would like to make a new PWM component or modify the current Matrix property but do not have the C code to make it as medelec35 said.
I think it is important as it will convert more functional component and for example in my case I can not do otherwise.
In the capture shown as configure the PWM to operate.
Thanks in advance
PWM Sinple or Half-bridge
Moderator: Benj
Forum rules
Only feature requests will be considered here. General questions should not be posted in this forum.
Only feature requests will be considered here. General questions should not be posted in this forum.
-
- Posts: 94
- Joined: Wed Jan 16, 2013 11:37 am
- Has thanked: 56 times
- Been thanked: 16 times
- Contact:
Re: PWM Sinple or Half-bridge
Hello again.
I think I have something misconfigured in CCP2 options because I do not get the two outputs of Half-bridge PWM.
Thank you.
I found the fault in the hardware, not the micro settings.
I think I have something misconfigured in CCP2 options because I do not get the two outputs of Half-bridge PWM.
Thank you.
I found the fault in the hardware, not the micro settings.
- Attachments
-
- capture project.jpg
- (208.63 KiB) Downloaded 627 times