DsPIC stops running if GLCD is included in the program

A forums to allow bugs and problems with Flowcode v6 to be reported and resolved.

Moderator: Benj

Zane
Flowcode v5 User
Posts: 195
Joined: Thu Sep 10, 2009 10:57 pm
Location: New Zealand
Has thanked: 91 times
Been thanked: 75 times
Contact:

Re: DsPIC stops running if GLCD is included in the program

Postby Zane » Fri Jul 01, 2016 10:01 am

Hi Ben,

No worries, i will look into that for you and post what i find. Enjoy your time off.

Thanks

Zane

Zane
Flowcode v5 User
Posts: 195
Joined: Thu Sep 10, 2009 10:57 pm
Location: New Zealand
Has thanked: 91 times
Been thanked: 75 times
Contact:

Re: DsPIC stops running if GLCD is included in the program

Postby Zane » Sun Jul 17, 2016 7:03 am

Hi Ben,

I have attached some code for a component to drive the 4D display running the R44 firmware revision (EB076_V2). This allows the display to initialise and also allows images to be displayed off the SD card. I hope this helps with sorting out the Flowcode component.

The only problem that this component has is that when the high speed baud rate is selected, the fastest I can drive the display is at 38400 bits/s. Any faster and the PIC starts sending data with errors, hence the high speed baud rate being set to 38400bits/s.

If anyone is interested in using this code and they are unfamiliar with creating components, open the attached flowchart and select “file” and then “ export component”. Save this component file in the components folder of FlowcodeV6 to make it available for use in a program.

Thanks
Attachments
Component4D_R44Picaso.fcfx
(48.88 KiB) Downloaded 89 times
These users thanked the author Zane for the post:
Benj (Mon Jun 19, 2017 10:03 am)
Rating: 5.56%