I have hit a brick wall with my project and I hope someone can help me.
My setup is as follows:
EB024 Bluetooth Board
EB005 LCD Board
I have been tasked to program a Microcontroller with a script that controls a Formula allcode robot. I was successful in doing this.
Next, I am required to fire a laser (which will be attached to the robot) for 1 second when an input is received from the keypad (attached to the microcontroller). My thoughts are to make use of a combination of the expansion ports and a transistor/relay as 5V is available on both expansion and servo port.
Any help would be much appreciated.
For Formula AllCode users to discuss projects, programs, and any other issues related to the Formula AllCode robotics platform.
2 posts • Page 1 of 1
- Posts: 4
- Joined: Tue May 02, 2017 9:57 pm
- Has thanked: 1 time
- Been thanked: 2 times
The solution was to make use of the E-Blocks Header which has pins that activate when the corresponding LED is lit. In my case, the transistor switch circuit was activated through pin E0 which toggles with LEDon/off (0).
- Rating: 11.11%