Does anyone know please how to actually enable registers on devices to use in Flowcode please?
I am trying to enable the Temperature Indicator Module on a PIC12(L)1571 and just don't know how to do it.
I want to be able to get the temperature into a Macro to check surface temperature of the device.
Here is the page from the data sheet - all ideas gratefully received!
Enabling A Register On A Pic
Moderator: Benj
-
- Posts: 267
- Joined: Mon Sep 14, 2009 10:34 am
- Has thanked: 30 times
- Been thanked: 19 times
- Contact:
Re: Enabling A Register On A Pic
Datasheet page here
- Attachments
-
- 19850970_334750753621790_781055845_o.png
- Page from data sheet
- (419.53 KiB) Downloaded 2975 times
-
- Flowcode v5 User
- Posts: 211
- Joined: Tue Feb 19, 2013 9:51 pm
- Has thanked: 72 times
- Been thanked: 177 times
- Contact:
Re: Enabling A Register On A Pic
I made an experimental internal temperature macro but, it is written in V5.
http://www.matrixtsl.com/mmforums/viewt ... ure#p57003
Here it is converted to V7 but, I have not tested it. Maybe a starting point for you though. Good luck.
http://www.matrixtsl.com/mmforums/viewt ... ure#p57003
Here it is converted to V7 but, I have not tested it. Maybe a starting point for you though. Good luck.
-
- Posts: 188
- Joined: Thu Jun 28, 2012 7:29 pm
- Location: Durham
- Has thanked: 86 times
- Been thanked: 186 times
- Contact:
Re: Enabling A Register On A Pic
Hi Sparkoids
If you don't have any luck with the component, I would like to give it try and make one for FC7. I have had a look at the base CAL for FC7, it appears to allow you to get access to all of the channels for the ADC block.
Let me know if you're interested.
Dave
If you don't have any luck with the component, I would like to give it try and make one for FC7. I have had a look at the base CAL for FC7, it appears to allow you to get access to all of the channels for the ADC block.
Let me know if you're interested.
Dave