Hello,
I'm trying to use this small 0.66" (64x48 pixel) display, however it's ok in simulation but in the real chip it looks like it's doubling the Y printing coordinate and also it's not possible to print anything when Y<7.
See how it looks in the simulation and in the real chip.
Could you please check the component?
Thanks
Giuseppe
GLCD (SSD1306) I2C component display.
Moderator: Benj
-
- Posts: 71
- Joined: Thu Aug 10, 2017 2:04 pm
- Has thanked: 25 times
- Been thanked: 36 times
- Contact:
GLCD (SSD1306) I2C component display.
- Attachments
-
- Test_OLED(SSD1306_I2C)_64x48_PIC18LF26K80_v1.fcfx
- (11.9 KiB) Downloaded 170 times
-
- Simulation_OLED(SSD1306_I2C)_64x48.jpg (19.31 KiB) Viewed 2517 times
-
- Test_OLED(SSD1306_I2C)_64x48.jpg (64.3 KiB) Viewed 2517 times
-
- Posts: 71
- Joined: Thu Aug 10, 2017 2:04 pm
- Has thanked: 25 times
- Been thanked: 36 times
- Contact:
Re: GLCD (SSD1306) I2C component display.
Hi,
just an update: if I set Property -> Dimensions -> Interlaced -> YES then the output looks better but still some part of the display (lower part) is not shown.
This should be an easy fix...please!!!
Regards
Giuseppe
just an update: if I set Property -> Dimensions -> Interlaced -> YES then the output looks better but still some part of the display (lower part) is not shown.
This should be an easy fix...please!!!
Regards
Giuseppe
- Attachments
-
- IMG_0803.JPG (28.98 KiB) Viewed 2505 times
-
- Posts: 71
- Joined: Thu Aug 10, 2017 2:04 pm
- Has thanked: 25 times
- Been thanked: 36 times
- Contact:
Re: GLCD (SSD1306) I2C component display.
Hi,
just an update to say that I've modified the component (thanks to Matrix Team to share!) and now the display is working as expected.
Regards
Giuseppe
just an update to say that I've modified the component (thanks to Matrix Team to share!) and now the display is working as expected.
Regards
Giuseppe
- Attachments
-
- Test_OLED(SSD1306_I2C)_64x48.JPG (61.33 KiB) Viewed 2470 times
-
- gLCD_SSD1306_i2c.fcpx
- (11.38 KiB) Downloaded 187 times