Hi,
I am using a PIC18F26K80 and the the eeprom fails to work correctly, it works fine in simulation. The program adds some initial values to the eeprom and then tries to read them back and display them. However only zeros are displayed. I have tried this with a PIC16F88 and it works ok.
Eeprom fails to work correctly
Moderator: Benj
-
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
Re: Eeprom fails to work correctly
Hi Zane,
Have you applied the fix posted here?
When applying fixes, if flowcode is open then you must select Reload before compiling otherwise the fix just applied won't work.
Martin
Have you applied the fix posted here?
When applying fixes, if flowcode is open then you must select Reload before compiling otherwise the fix just applied won't work.
Martin
Martin
-
- Flowcode v5 User
- Posts: 199
- Joined: Thu Sep 10, 2009 10:57 pm
- Location: New Zealand
- Has thanked: 93 times
- Been thanked: 76 times
- Contact:
Re: Eeprom fails to work correctly
Hi Martin,
Thanks for pointing this fix out, most appreciated.
Cheers
Zane
Thanks for pointing this fix out, most appreciated.
Cheers
Zane