Page 2 of 2
Re: Uart RX to 2 TX
Posted: Wed Aug 09, 2017 3:13 pm
by medelec35
You will need to disable PLL x 4
You will need to make sure timing is correct by creating a
one second flasher.
I do that for all my new projects first.
Also the image shows
and not
With that and image looks like Flowcode V7 I'm going to move this thread to V7 section.
Martin
Re: Uart RX to 2 TX
Posted: Wed Aug 09, 2017 10:22 pm
by kabouras_33
I already confirmed the 1sec flasher but I will try again tomorrow.
OSCOON=0X70 was my original but I changed in order to achieve 10MHz but both made no difference...
Tomorrow I will disable pllx4 and try again!!
Please do not move the topic because I own fc6 I just download demo 7 to try and see.
I will continue with 6 again from now sorry for the mix up!
Re: Uart RX to 2 TX
Posted: Tue Aug 15, 2017 10:00 pm
by kabouras_33
So after a lot of trial and error i found my problem which you all ofcourse clearly point me too and i DEEPLY DEEPLY thank you very much.
It was the configuration settings and the crystal.
After some testings with a 16f877a i found that HS and 4MHz setting and crystal should be used.
I tranfer this settings to the 18f46k80 and it worked like a charm!!!
You are all great thank you all!!!