Hello,
I have been wanting to try some simulation on my code - some basic RS232 simulation. I have tried repeatedly to use the console in conjunction with the data injector to simulate some input. The problem is that I cannot see the console anywhere on my screen. I have tried to reset the views(restore window layout) to no avail. Is this now part of the debug package/add on? Is the console something that needs to be programmed into my code? If so, are there any examples that I see? I click on the "Console" in views and never have any luck bringing up the console. If anyone has any suggestions or can point out what I am missing, I sure would appreciate the help. I'm currently running v7.3.0.5.
Thanks
Missing Console
Moderator: Benj
-
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
-
- Posts: 10
- Joined: Wed Dec 13, 2017 2:37 am
- Has thanked: 1 time
- Been thanked: 2 times
- Contact:
Re: Missing Console
Okay, I looked at the post. Just so I'm clear in my understanding, the Console feature is indeed a part of the Test/debug package. I do not have that package in my license window. Thanks for clarifying this. I could not figure out where the console was and thought that I had deleted or closed something I shouldn't have. I will look into getting the test/debug package soon.
Thanks again.
Thanks again.
-
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
Re: Missing Console
your welcome.
In my opinion the console is a very important part if using RS232.
I have never developed a flowchart involving RS232 without using console.
In my opinion the console is a very important part if using RS232.
I have never developed a flowchart involving RS232 without using console.
Martin