Really new to using pics
Just come back from a friends house attempting to program a 16lf1903 using flowcode 5.5 and a very old Pic Micro development board V2 (2001)
I have tried making a very simple (Turn A0 on, wait 300ms, turn A0 off, Wait 300ms) it programs fine but will not do anything, in trying to configure the chip i get the error (Unrecognised chip on command line <PIC16LF1903>)
We tried programming a 16F628 and that worked fine, are we being daft or is there an issue with flowcode and these chips, we tried 2!
We want to use this chip as it has more outputs than the 628.
Thanks for any help
Ben
Cannot seem to get a 16lf1903 to do anything
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: Cannot seem to get a 16lf1903 to do anything
Hello,
The problem is probably down to your configuration settings. Could you upload your project files and describe your hardware setup, oscillator etc I will have a look for you.
The problem is probably down to your configuration settings. Could you upload your project files and describe your hardware setup, oscillator etc I will have a look for you.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel