For a bigger program as normal, i have thosen this one 18F26K20.
it works in simulation, but does not work at the board.
For test I made a simple program one input port A (0) and one output in B(0), if port A0 = 1 than B0 is 1 (led On)
It works in simulation mode, but still not at the board (EB006-00-7), Im using Flowcode V5.x
after sent it to the PIC:
Writing program memory
Writing configuration memory
Programming failed: <1><2><3><5><6><8><9><10><11>
That took 4,14 seconds
Resultaat = 0
I think the problem is in the chip configuration, with all the adjust possibilities, but which are the correct one?
I select the HS in settings and on the board both switches to the right.
Have some experience with this type of microchip?
For questions and comments on programming in general. And for any items that don't fit into the forums below.
1 post • Page 1 of 1