ADVICE USING RB0 INT FUNCTION
Posted: Sat Jan 19, 2019 12:04 pm
hi all
im looking for advice whilst using the RB0 int function on a pic (16f 887), if i set it for say trigger on the rising edge would i need to use say a 10K resistor to pull it low and vice versa ie falling edge and a 10K pull up resistor or can the bit just be connected without the resistors ?? cheers
bob
im looking for advice whilst using the RB0 int function on a pic (16f 887), if i set it for say trigger on the rising edge would i need to use say a 10K resistor to pull it low and vice versa ie falling edge and a 10K pull up resistor or can the bit just be connected without the resistors ?? cheers
bob