PIC32 Bit Timings and Peripheral Issues
Posted: Thu May 18, 2017 12:19 pm
Hello,
Right we've had a few reports of delays and other peripherals not quite acting correctly on the PIC32 hardware.
I have purchased a range of chips and have been playing with the various reports.
If we could try and get all the problems covered here in this topic then hopefully we can get them all fixed and working.
Ok so I have started with the MX range of chips.
Here are my config settings and performing a 1 second flasher program I get 1 second delays.
Firstly here is a new UART CAL which fixes the baud rate problem for the MX family when using a divide by 1 peripheral clock divisor.
At the moment I am investigating the timer interrupts as there are reports that these are currently generating incorrect frequencies.
Right we've had a few reports of delays and other peripherals not quite acting correctly on the PIC32 hardware.
I have purchased a range of chips and have been playing with the various reports.
If we could try and get all the problems covered here in this topic then hopefully we can get them all fixed and working.
Ok so I have started with the MX range of chips.
Here are my config settings and performing a 1 second flasher program I get 1 second delays.
Firstly here is a new UART CAL which fixes the baud rate problem for the MX family when using a divide by 1 peripheral clock divisor.
At the moment I am investigating the timer interrupts as there are reports that these are currently generating incorrect frequencies.