on PIC32Mz2048 Pin C14 not working

For Flowcode users to discuss projects, flowcharts, and any other issues related to Flowcode 8.

Moderator: Benj

Post Reply
stefan.erni
Valued Contributor
Valued Contributor
Posts: 654
Joined: Fri Aug 19, 2016 2:09 pm
Location: switzerland
Has thanked: 182 times
Been thanked: 179 times
Contact:

on PIC32Mz2048 Pin C14 not working

Post by stefan.erni »

Hi Ben

On PIC32Mz2048ECG100 Pin C14 is not working as an input.
I suspect there is the second oscillator configuration where the problem on this PIN caused.

The pin has 2.0 Volt DC
How can I config it?
regards
Stefan
Pin.PNG
(85.33 KiB) Downloaded 681 times
config.PNG
(10.73 KiB) Downloaded 681 times

stefan.erni
Valued Contributor
Valued Contributor
Posts: 654
Joined: Fri Aug 19, 2016 2:09 pm
Location: switzerland
Has thanked: 182 times
Been thanked: 179 times
Contact:

Re: on PIC32Mz2048 Pin C14 not working

Post by stefan.erni »

Hi Ben

The Pin is working as an output. I put a Led on the output and when I start the board, the Led is ligthing a litle. (2 Volt)
But when the program set the pin to low, then Led stop to ligthing and if the program set the pin to high the Led is ligthing full.(3.3 Volt)

So it's solved....

regards

Stefan

Post Reply